NavalDrill Frequency (46 CFR 199.180)
Twenty flashcards on how often inspected vessels drill: monthly drills, the 24-hour rule, boat launches, training and the logbook.
Free to start20 cards
- What is the monthly minimum for every crewmember?
- At least one abandon-ship drill and one fire drill every month.
- When must drills happen within 24 hours of leaving port?
- When more than 25 percent of the crew missed abandon-ship and fire drills on that vessel the previous month.
- When must drills be held before sailing?
- When the vessel enters service for the first time, after a major modification, or when a new crew is engaged.
- How does an abandon-ship drill begin?
- The general alarm calls everyone to muster stations, followed by announcements so all know the order to abandon ship.
- What is checked on people at the muster?
- That they are suitably dressed and their lifejackets or immersion suits are correctly donned.
- Which boat actions belong to the abandon-ship drill?
- Lower at least one lifeboat, start and run its engine, and operate the liferaft davits.
- Should the same lifeboat be lowered at every drill?
- No; as far as practicable, different lifeboats at successive drills.
- How often must each lifeboat be launched with its crew and maneuvered?
- At least once every 3 months during an abandon-ship drill.
- What is the rule for a free-fall lifeboat?
- Free-fall launched with its crew at least once every 6 months; the OCMI may extend to 12 months with simulated launches at most every 6 months.
- How often are rescue boats launched and maneuvered?
- Each month as far as reasonable, and at least once every 3 months.
- How often is the line-throwing appliance drilled?
- At least once every 3 months; actually firing it is up to the master.
- How often do crewmembers wear immersion suits in a drill?
- In at least one abandon-ship drill in any three-month period; if too hot, they get instruction instead.
- What must be tested at every abandon-ship drill?
- The emergency lighting for mustering and abandonment.
- How is the fire main checked in a fire drill?
- Start the fire pumps and use two jets of water to see that the system works.
- What else is checked in a fire drill?
- Firefighter outfits and rescue gear, communications, watertight and fire doors, fire dampers and ventilation inlets and outlets.
- What happens to the equipment after a drill?
- It goes back to fully operational condition at once; faults found are fixed as soon as possible.
- When must a new crewmember get onboard training on lifesaving and firefighting gear?
- As soon as possible, and not later than 2 weeks after joining the vessel.
- In what period must instruction cover all lifesaving and fire gear?
- Within any period of 2 months.
- How often is training on davit-launched liferafts given?
- At intervals of not more than 4 months, inflating and lowering a raft whenever practicable.
- What goes in the official logbook after a drill?
- Date and time, equipment used, faulty gear and its fix, who took part, and the training subject.
Official sources
46 CFR Part 199: Lifesaving Systems for Certain Inspected Vessels
Making Synapses is not affiliated with, sponsored by or endorsed by the U.S. Coast Guard or any maritime authority. Regulations are named only to describe the content.